carriage driver_move_gain mgain All Carriage stepper motor current when at peak speed while moving to position (i.e. moving when not plotting). Normally, this parameter should not be changed from the factory default. Maximum current is 254. Setting this current too low may lead to the carriage stalling while moving. integer

254

0 to 254

cal

../nvs/carriage_cal_pgain.xmlNVS: carriage pgain

../nvs/carriage_cal_hgain.xmlNVS: carriage hgain

../nvs/carriage_cal_again.xmlNVS: carriage again

..\..\ShowAllErrors.htmFirmware 0 Error Index

..\..\ShowAllCommands.htmFirmware 0 Command Index

..\..\ShowAllNVS.htmFirmware 0 NVS Index

Updated: Wed Jul 16 19:36:40 2008 PST